Hi guys..... this is the wire from some ancient servo. Im afraid to plug it into the receiver in case its the wrong order of wires(and it doesn't fit)....how do I work out which is which....one of the wires on the edge(at the bottom of pic) has a gray line up the length of it...is that normally positive or the red wire?




I plugged one in wrong once and it created smoke...so a bit afraid!
Miles
_________________
Miles Blow - Julie Pitts
www.mulesfilm.com.au
www.wombokforest.com.au

-Pickasso- Vivid Sportsman champion 2015

hmmm if its a normal servo lead plugging it in backwards shouldn't matter however by the sounds of it this is wrong. Usually one edge is GND, center is +V and other is SIGNAL. I would assume grey wire is signal though really no way to tell.

Got photos of controller board?

Steve
_________________
Steven Martin
Twisted Constructions
http://www.botbitz.com

i was always taught the lighter colour in the loom is always positive. though who knows with that dinosaur. is it even compatible with a modern reciever
_________________
www.demon50s.com - Minimoto parts
http://www.youtube.com/user/HyzerGlen - Videoooozzz

Hi guys thanks for the info..will do a bit of experimenting.
miles
_________________
Miles Blow - Julie Pitts
www.mulesfilm.com.au
www.wombokforest.com.au

-Pickasso- Vivid Sportsman champion 2015