miles&Jules
Experienced Roboteer
Joined: 19 May 2010
Posts: 3973
Location: ipswich QLD
|
Turnigy 9x Radio -robot Mixing
Hi Guys
Finally got the mixing going on this transmitter
[/URL]
The trick is to have your left and right motors escs plugged into Aux 1 and 2 on the receiver
Set it to acro mode.
The only annoying bit is ….in the menu the Aux 1 and Aux 2 aren't labelled as that- they are just next to each other (both saying Aux) so you have to count the beeps.
You need to do 4 separate mixes (annoying)
So plug you motors into channel 7 and 8
(aux channels) For me Right wheel is 7 and Left wheel is 8
So to set it up... go to program mix……
Mix1
STATE =Act
Master =Ele
Stave =Aux1
Offset =000
Uprate =100
Dnrate =100
Sw = on
Mix2
STATE = Act
Master = Ele
Slave = Aux 2
Offset = 000
Uprate =100
Dnrate =100
Sw = on
Mix3
STATE = Act
Master = Ail
Slave = Aux1
Offset =000
Uprate = -100
Dnrate = -100
Sw = on
mix 4
STATE = Act
Master = Ail
Slave =Aux2
Offset =000
Uprate =100
Dnrate =100
Sw = on
this works great on Kojak….but if you have your motors wired the other way around…then you will either need to swap motor channels or change the ( - )values in the mix.
Thought I would post this so you know its another radio option and ….If I ever forget ….he he…its written down
Also here is a life battery that fits nice…. all the quad heli fliers use.
[/URL] _________________ Miles Blow - Julie Pitts
www.mulesfilm.com.au
www.wombokforest.com.au
-Pickasso- Vivid Sportsman champion 2015
|