Hammer

Lightweight

As seen above with Hellfire about to flip it in it's current form

Armor/Chassis: 3.2mm Hardox 450
Drive: 4 x 100watt Scooter Motors @ 36v, with two stage 4:1 #25 chain reduction
Electronics: Spektrum DX6 & PicAxe Relay Controllers (Maybe a PWM version)
Batteries: 36v 2400mAh NiCD
Weapon: Hardox Wedge

I did a deal with Trent, buddy ole pal, he gave me the half build, first bot he started, and I wouldn't charge him for his share of the Hardox The idea of this bot, is for me to learn the difficulties of working with Hardox before attacking it with my new featherweight. I will also get some experience with chains and sprockets. An offset to the learning, I'll have a lightweight to hoon around with and take to events that support them. Also, I think the local skatepark just got a lot more exciting I'll post a CAD up of the modifications I'll be doing to it when I start construction. If I'm lucky, I might even make it to Battleshed with it...
_________________
https://www.halfdonethings.com/

Last edited by Knightrous on Thu May 10, 2012 3:52 pm; edited 1 time in total

sweet if you do I call grudge match wheelie(rubber) VS Hammer (hardox)
_________________
A journey of a million miles begins with a single step followed by a hell of a lot of other steps so get walking

Have fun mate.
_________________
Imagination is more important than knowledge. Knowledge is limited. Imagination encircles the world.
Albert Einstein.

Oh, I will

List of "Nasties" to do with Hammer

- Run into cars with ricer body kits
- Run into people's ankles
- Chase Cats/Dogs with it
- Take over the skatepark
- Do donuts with it on the lawns of peoples homes that have a "Keep off the Grass" signs...


_________________
https://www.halfdonethings.com/

Update on the new chassis. Trying out some different build techniques on this. Making the panels have locking tabs to hopefully make the frame stronger when welded. Enough tinkering in CAD tonight, will go watch Raiders of the Lost Ark now
_________________
https://www.halfdonethings.com/

U know to expect the 10mm axles to bend with abuse don't ya?
_________________
Imagination is more important than knowledge. Knowledge is limited. Imagination encircles the world.
Albert Einstein.

Hence why they are 12mm 4140 and will be hardened And if they bend still, shit happens, I'll fix it next time
_________________
https://www.halfdonethings.com/

Chain layout has been done. Finished cading the bearings and the positions. Will move ontto finishing the last body panels now and schtuff.
_________________
https://www.halfdonethings.com/

_________________
https://www.halfdonethings.com/