Joined: 19 May 2010
Posts: 3973
Location: ipswich QLD
Lathe tailstock die holder
just got this bad boy on ebay from an aussie company- about to test this out on some 8mm stainless rod ftom a printer- i was supprised and impressed by the hole all the way through so you could do a seriously long thread with this thing😃
_________________ Miles Blow - Julie Pitts
www.mulesfilm.com.au www.wombokforest.com.au
-Pickasso- Vivid Sportsman champion 2015
Thu Jun 25, 2015 2:18 pm
miles&Jules Experienced Roboteer
Joined: 19 May 2010
Posts: 3973
Location: ipswich QLD
Joined: 16 Jun 2004
Posts: 11802
Location: Sydney, NSW
That's a pretty good result, what is the largest sized thread you can cut with it? _________________ Australian 2015 Featherweight champion
UK 2016 Gladiator champion
Fri Jun 26, 2015 9:59 pm
miles&Jules Experienced Roboteer
Joined: 19 May 2010
Posts: 3973
Location: ipswich QLD
It takes a 1" die - so it will tap anything that fits - it probably has 30mm of threading depth for big stuff and probably go really deap with stuff below 8mm all that would be stopping it for the thin stuff is the back of the tail stock- i bought this so the bolts are straight for my bolex anamophic camera mount i was talking anout in another thread
_________________ Miles Blow - Julie Pitts
www.mulesfilm.com.au www.wombokforest.com.au
-Pickasso- Vivid Sportsman champion 2015
Sat Jun 27, 2015 4:36 pm
Forum Jump:
Page 1 of 1
Forum Rules:
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
RoboWars Australia Forum Index
-> Technical Chat
just got this bad boy on ebay from an aussie company- about to test this out on some 8mm stainless rod ftom a printer- i was supprised and impressed by the hole all the way through so you could do a seriously long thread with this thing😃
sexy man😎
